Ambient Conditions - Renfert Vario jet Instrucciones Para El Servicio

Ocultar thumbs Ver también para Vario jet:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 39
ENGLISH
1. Introduction
We are delighted that you have decided to purchase
the Vario jet recycling sandblaster. This unit sets new
standards with regard to function, efficiency, safety
and ergonomics. Please note the following tips in
order to ensure a long and problem-free service life.
2. Description /
Applications
The Vario jet recyclable sandblaster is for use in
dental laboratories in order to carry out the remov-
al of residual investment material and oxides from
frameworks (mainly model casting). It boasts a touch
control pad that is not affected by dirt and is sealed
against dust in order to ensure long and problem-free
functioning.
The recyclable sandblaster can be set to manu-
al or automatic mode dependent on choice. The
construc-tion of the unit ensures excellent blasting
efficiency within a short period of time and uses
comparatively less blasting material (on average
100 - 300 g per hour, dependent on extractor unit).
The funnel-shaped sand silo capacity of more than
5 kg allows long periods free from interruption. The
parameters of working pressure, time, automatic /
manual and extraction On / Off + run-on time (via an
external unit) can be set on a sliding scale within the
total potential.

2.1 Ambient Conditions

(in accordance with DIN EN 61010-1)
The Vario jet may only be operated:
• Indoors;
• Up to an altitude of 2.000 m [6.500 ft] above sea
level;
• At an ambient temperature of 5 - 40 °C
[41 - 104 °F]
;
*)
• At a maximum relative humidity of 80 % at 31 °C
[87.8 °F], decreasing linearly to 50 % relative hu-
midity at 40 °C [104 °F]
• With a mains power supply where current fluctua-
tions do not exceed 10 % of the nominal value;
• Under level 2 contamination conditions;
• Under overvoltage category II conditions.
*)
Between 5 – 30 °C [41 - 86 °F], the unit can be operated at a
relative humidity of up to 80 %. At temperatures between
31 - 40 °C [87.8 - 104 °F], the humidity must decrease propor-
tionally in order to ensure operational readiness (e.g., at 35 °C
[95 °F] = 65 % humidity; at 40 °C [104 °F] = 50 % humidity).
The unit may not be operated at temperatures above 40 °C
[104 °F].
Vario jet
No. 2961-0000 / 2961-1000
;
*)
3. Areas of Caution
Vario jet is an electrical appliance with a
danger potential. This appliance may be
connected / used only by authorized and
qualified persons after checking its confor-
mity with respect to the national norms.
Never operate a sandblaster without a
suitable dust extraction unit or suitable
personal protective clothing as this can be
detrimental to your health. The type of dust
extractor must relate to the type of dust
produced by your sandblasting work. It is
imperative to adhere to the legal regulations
(in Europe this means EN 60335-2-69).
Before operating check the electrical and
pneumatic leads for damage.
If defects are found do not activate or con-
tinue to use the unit.
Before opening the unit remove the plug
from the socket.
Before changing the fluorescent lamp make
sure it is unplugged.
Do not push the lamp too hard (danger of
breakage!). Wear gloves or use a protective
cloth!
Do not sandblast unprotected skin
>>> danger of injury!
Before connecting the unit check the volt-
age against that on the unit ID.
The unit interrupts blasting when the pro-
tective glass is open. Do not readjust the
switch. Escaping blasting material may
cause eye injury.
It is the responsibility of the operator that
national regulations during operation and
regarding a repeated safety inspection of
electrical equipment are complied with.
For Germany these are the regulation 3 by
DGUV (German Statutory Accident Insur-
ance) in relation with VDE (Association for
Electrical & Electronic Technology) 0701-
0702.
Only spare parts and accessories supplied
or authorized by Renfert GmbH may be
used with this product. If other spare parts
or accessories are used, this could have a
detrimental effect on the safety of the de-
vice, increase the risk of serious injury and
lead to damage to the environment or the
device itself.
- 1 -
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

2961-00002961-1000

Tabla de contenido