Operation; Adjusting The Sensitivity - Defiant DFI-7167-WH Guía Para El Uso Y Cuidado

Luz solar de seguridad con detector de movimiento
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation

1
Adjusting the lamp head
If needed, gently grasp the lamp head (A) and
tilt it up or down or side to side to adjust the
light coverage area.
2
Determining the motion sensor
detection zone
NOTE: When the control dial is set to the "TEST" position,
the light will operate during the day or night. The light will
stay on for 5 seconds after all motion is stopped.
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.
Turn the control dial (D) to the TEST position.
Turn the sensitivity dial (E) to the "L" position.
Perform a "walk test": walk in an arc across
the front of the motion sensor (C).
Watch the light (B). The light (B) will come on
indicating motion has been detected.
Stop, wait for the light (B) to turn off, and then
begin walking again.
Continue this process until the detection zone
has been established.
3

Adjusting the sensitivity

If needed during the "walk test", turn the
sensitivity dial (E) to the desired sensitivity
("L", "M", "H").
NOTE: The motion sensor is more sensitive to motion
moving across the front of the sensor. The motion sensor is
less sensitive to motion moving directly toward the sensor.
NOTE: The higher the sensitivity setting, the greater the
possibility of false triggering. To reduce false triggering,
turn the sensitivity dial to the "L" or "M" position.
TEST
OFF
60S
W
B
C
W
10
A
W
W
B
D
E
M
L
H
E
M
L
H

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

1005126720

Tabla de contenido