Pre-Installation; Planning Installation; Initial Battery Charge; Mounting Location - Defiant DFI-7167-WH Guía Para El Uso Y Cuidado

Luz solar de seguridad con detector de movimiento
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Pre-Installation

PLANNING INSTALLATION

Before installing the light fixture, ensure that all parts are present. Compare parts with the Hardware Included and
Package Contents sections. If any part is missing or damaged, do not attempt to assemble, install, or operate this
light fixture.
Estimated installation time: 30 minutes

INITIAL BATTERY CHARGE

IMPORTANT: The solar panel requires full, direct sunlight to charge the battery. Clouds, rain, snow, and other weather conditions may not allow the
solar panel to completely recharge the battery. Other obstructions such as buildings or trees may block the sun as well.
When installing the solar panel, make sure it is aimed as described below with a minimum amount of obstructions. If possible, mount the panel facing
toward the southern sky.
PRIOR TO USE, the battery will require 3 to 7 days of full sun to completely charge with the control dial in
the OFF position. Plug the solar panel cable into the connector extending from the side of the light fixture. If
possible, aim the solar panel toward the south and tilt it approximately 50° from horizontal. If the solar panel
cannot be aimed toward the south, then tilt the panel approximately 30° if possible.
Actual operating time will vary depending upon how frequently the light is turned on by the motion sensor.
Solar lighting is not designed to equal standard 120V lighting. The amount of light output is reduced to allow
the sun time to fully recharge the battery between lighting cycles.
Solar collection is only effective in direct sunlight. Every hour the light is on requires a minimum of 16 hours
of sunlight charging. Solar panels collect less than 10% of the sun's energy.

MOUNTING LOCATION

The most important thing to remember for the operation of your solar powered motion sensing light is that it works
from the power received from direct sunlight. The more direct sunlight the solar panel receives in a day, the longer
the light will operate.

SOLAR LIGHT FIXTURE

The main unit contains the LEDs and motion sensor. When deciding where to mount this unit, keep in mind that the
motion sensor that activates the light has a "field of vision" of 40 feet (12 meters) in front of the light and about
180° detection angle at a surrounding air temperature of 77° F (25 °C).

SOLAR PANEL

The solar panel converts the sun's energy into electricity, thus charging the battery stored in the solar panel. The
solar panel requires direct sunlight falling onto the face of the solar panel for as long as possible over the course of
the day.
When choosing the location for the solar panel, make sure it is aimed toward the south and is tilted to a suitable
angle to allow as much direct sunlight to fall upon it as possible. Make sure there is a minimum amount of
obstructions between the solar panel and the sun.
Also, make sure your solar panel location is not too far away from the solar light fixture for the wires to reach and
connect.
3
Please contact 1-866-308-3976 for further assistance.
HOMEDEPOT.COM

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

1005126720

Tabla de contenido