Echo SRM-261T Guia De Inicio Rapido página 2

2
INSTALLATION INSTRUCTIONS U-HANDLE COMBO KIT
-
INSTALLING U
Tools Required: 8mm x 10mm Open End Wrench, 3mm and 4mm Hex
Wrench, T-Wrench
Install U-Handle
1. Close choke and remove air filter and cover.
2. Disconnect ignition stop leads (A) and (B).
3. Loosen nut (C) and remove throttle linkage from carburetor
bracket.
4. Remove inner throttle linkage from carburetor swivel (D).
5. Loosen bolt (E) and pull drive shaft assembly from clutch case.
6. Loosen two (2) rear handle screws (F) and pull rear handle from
the drive shaft assembly.
7. Loosen four (4) screws (G) and remove front handle.
8. Insert square nut (H) in lower handle bracket (I) and place bracket
on drive shaft 483mm (19 in.) from engine end of drive shaft.
9. Secure with lower handle bracket clamp (J) and three (3) 5mm x
30mm bolts.
HANDLE
G
H
I
J
483mm (19 in.)
D
C
B
A
E
F
ENGINE
END