Installation - Sony BKM-FV50 Manual Del Usuario

Installation

Before installation
• Turn off power to the display and all
other equipment connected to the display.
For the display, proceed as follows: press
1 to put the display into standby mode
and then disconnect the power cord from
the AC outlet.
• While carrying out the installation, the
display must be firmly secured.
Install the BKM-FW50 inside the display
as follows.
1
If an optional adaptor is installed,
loosen its fastening screws (top and
bottom) by turning counterclockwise
with a flatblade screwdriver and then
carefully pull out the adaptor from
the display.
When option slot is at
left of display *
2
* The location of the option slot differs
according to the model. On models with
multiple option slots, use a slot that
supports video/communication functions
(VIDEO/COM port). Consult the
documentation of the FWD series product
for more information.
6
Installation
2
Insert the BKM-FW50 into the
display with correct orientation.
Make sure that the adaptor is firmly
seated in the internal connector of the
display. Then tighten the fastening
screws (top and bottom) with a flatblade
screwdriver and perform the necessary
connections.
2
2
Caution
Do not touch the connector section
Never touch the connector section inside
the display. Otherwise there is a risk of
accidents or damage.