Uline H-2584 Guia De Inicio Rapido página 2

For use with 2" wide high tensile steel strap, .044" to .050" thick. This tool uses the following seals: S-15311.
1. Fully open the sealer handles and place the open
jaws to one end of the seal. (See Figure 2)
Figure 2
2. Bring the sealer handles completely together to
assure a proper notch. (See Figure 3)
Figure 3
Inspect tool daily for worn or broken parts and replace
if necessary. Clean and apply light machine oil to all
moving parts weekly.
PAGE 2 OF 6
SPECIFICATIONS
OPERATING INSTRUCTIONS
3. Remove the sealer. Place the sealer on the opposite
4. To avoid contact with the sharp end of the strap,
MAINTENANCE
1-800-295-5510
uline.com
end of the seal and apply the remaining notch by
bringing handles completely together. Remove the
sealer when through.
NOTE: If the gauge of the strap being used will
not allow it to be bent, cut the strap supply
as close to the seal as possible using an
approved strap cutter.
retract the strap end back into the strap dispenser.
WARNING! Inspect all parts daily and replace
them if they are worn or broken. Failure to do
this can affect the product's operation and
could result in serious personal injury.
0621 IH-2584