Remote Sensor; Getting Started; Insert Batteries - Oregon Scientific BAR206X Manual Del Usuario

1. °C / °F: Select temperature unit
2. RESET: Reset unit to default settings
3. EU / Uk / US: Select the nearest radio signal
REMOTE SENSOR (FIG 3)
1
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole
5. CHANNEL switch
P/N: 300100678-00012-10 REV1.0
5/72
2
3
4
5

GETTING STARTED

INSERT BATTERIES

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (see FIG 2).
3. Press RESET after each battery change.
LOCATION
Clock / alarm and indoor
temperature area
Outdoor temperature area

REMOTE SENSOR

The main unit can collect data from up to 3 sensors.
To set up the sensor:
1. Open the battery compartment (see FIG 3).
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 1.5 m (5 ft) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
3
MEANING
Main unit batteries low
Sensor batteries low