GYS SPOT LIFT Manual De Instrucciones página 16

Translation of the original instructions
The commands are actionned but the
jack does not lift
The jack lowers by itself
Pump's oil leak
Hosepipe's oil leak
Connectors' oil leak
DESACTIVATION
Any machine that appears damaged in any way, does not operate normally, or lacks parts should be immediately taken
out of service by removing the air connection from the hydraulic pump. Do not use the unit if you notice parts are bro-
ken, bent or cracked.
START-UP
The jack must be disposed of in accordance with current environmental and country disposal guidelines.
SPECIFICATIONS
Weight (pump included)
Maximum vehicle load
Maximum lifting
Product height
Product width
Product length
Operating mode
Hydropneumatic pump
Pump's sound level
16
Excessive load
Compressed air exhaust silencer
obstructed
The air supply is insufficient
Pump's discharge valve is clogged
Seals are worn out
Hosepipe worn out or cracked
Connector worn out or cracked
If the hydropneumatic pump fails, it is dangerous to replace it with an alternative product. Using
another pump can lead to serious accidents and/or product deterioration. Repairing the pump and
the jack can only be performed by qualified GYS personnel.
SPOT LIFT
Check the vehicles's weight
and observe the manufacturer's
instructions.
Clean or replace the compressed air
exhaust silencer.
Check that the air pressure is
comprised between 6 and 8 bar.
Contact the manufacturer before
proceeding to any repair
Contact the manufacturer before
proceeding to any repair
Replace the hosepipe
Replaced the cracked connector
85 kg
2500 kg
995 mm
1290 mm
730 mm
1050 mm
Hydropneumatic
220 bar
72 dB (A)
EN