Össur REBOUND DUAL Instrucciones De Uso página 6

cruciate and bottom straps AND tighten the anterior tibial strap.
Proper anterior/posterior placement will help prevent migration and
ensure proper brace suspension.
Warning: If brace causes discomfort or irritation, discontinue use
immediately and contact your health care provider.
BRACE MAINTENANCE
The Rebound DUAL brace is designed for minimum maintenance and
care. Follow these easy maintenance steps to keep your brace in good
condition.
CLEANING
• Liners, straps and pads may be removed for cleaning
• Do NOT machine wash
• Do NOT place in dryer
• Hand-wash using mild non-detergent soap
• Rinse thoroughly
• Air-dry
If migration occurs, clean lower liners and pads with an alcohol wipe or
damp cloth. If brace is used in salt water or chlorinated water, rinse well
and air dry.
HINGE MAINTENANCE
• Do NOT disassemble the hinge
• Check regularly for foreign materials in hinge (i.e. dirt or grass)
• Carefully clean dirt from hinge using water or compressed air
• Lubricate with silicone spray or dry graphite if needed
ACCESSORIES
The following accessories are available for your Rebound DUAL brace at
an additional charge.
To order call your Össur Customer Service Department.
• SmartDosing kit
• Flexion stop kit
• Liner kit
• Strap kit
• D-ring kit
• Extension Stop Kit
SETTING UP THE D-RING
The field-serviceable d-rings can be changed from internal to external
d-rings or replaced if a d-ring is broken. The following instructions show
reconfiguration of internal to external d-rings.
1. Remove strap from d-ring.
2. Bend d-ring and push inward on internally mounted d-ring to
disengage keyhole lock to remove from rivet. (Figure 6)
3. Replace d-ring to external configuration by pushing down onto rivet
through the keyhole lock and sliding to click the d-ring into place.
Keyhole lock should be placed with indentation side face up.
(Figure 7)
4. Replace strap.
5. Repeat on other d-rings as needed.
6