Fuse Replacement - TechGrow Pro Serie Manual

9. Fuse replacement

If the Humi Dual Pro is overloaded or in the event of a
short circuit, the internal fuse will blow. The fuses are
placed at the front panel, at the right of the outlets. (Left
outlet: dehumidifier, right outlet: humidifier.)
To replace the fuse, go through the following steps:
1. Press the black fuse holder slightly with a
screwdriver and turn it a quarter of a turn
counterclockwise.
2. Remove the fuse holder.
3. Remove the blown fuse.
4. Insert a new fuse with similar specifications in the
fuse holder.
5. Reinstall the fuse holder in the housing of the Humi
Dual Pro.
6. Then press the fuse holder again with a screwdriver
and tighten it by turning it a quarter turn clockwise.
Your Humi Dual Pro is ready for use again.
ATTENTION: Two new fuses are supplied, one for
each output. Make sure you use the correct fuse
when replacing. Damage caused by the use of
incorrect fuses is not covered by warranty.
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions 14