Led Indicators; Communication Interfaces - HandHeld Quick Check 890 Guia De Inicio Rapido

Physical Connections
A DC power barrel on the back of the unit connects to a power supply for external
power and battery charging.
The DB9 port on the unit connects to the pen wand, mouse wand, or 3800V
imager. If you are using any of these devices, refer to the QC890 User's Guide
for additional information.
The RJ45 ten pin connector provides the RS-232 serial or USB interface to the
host. Refer to "USB Communication Interface" on page EN-2
Serial Communication Interface" on page EN-4
unit.

LED Indicators

LED Indication
Green Solid
Green Flash
Red Flashing
Orange Solid

Communication Interfaces

The QC890 Verifier system supports the following interfaces: USB, RS-232, and
®
Bluetooth .
USB Communication Interface
Before connecting the QC890 Verifier, you must load Quick Check ImageData
software from the CD that was included in your kit. Install Quick Check
ImageData software from the CD to your host system.
EN-2
Cause
Charging
Good read
Low battery
Battery too low for unit to operate (plug in external power supply)
and
for details on connecting your
"RS-232