Dremel 4300 Instrucciones De Funcionamiento página 25

1600A00N3H.qxp_4300 7/8/16 10:34 AM Page 25
EZ Lock™ Mandrel No. EZ402 has a spring
loaded sleeve and is used with cutting
wheels, abrasive buffs and polishing cloth.
before changing accessories. Incorrect
seating of wheel on mandrel may lead to
personal injury orproperty damage.
To load accessory:
1. Place EZ Lock™ mandrel into chuck as
deep as possible.
Note: there is a blue spacer on the
mandrel that will bottom out on the EZ
Change™ chuck, setting the mandrel to
the correct depth.
2. Pull spring-loaded sleeve DOWN towards
tool with one hand and hold. You can
brace the tool on the body or work-bench
for extra leverage (Fig. 1).
3. With the other hand, align bowtie shape on
cut-off wheel with mandrel and make sure
metal insert is facing away from the tool
(Fig. 2).
4. Place wheel on the mandrel to a point just
below the bowtie on the mandrel and twist
90 degrees until the bowtie shape on the
wheel aligns with the sleeve. Release
sleeve. Wheel should lock in place (Fig. 3).
5. When mounting sanding and polishing
accessories, align bowtie with metal insert
on bottom of accessory (Fig. 4 & 5).
To check for proper seating, hold shaft lock
button and twist accessory. Accessory will
not be able to rotate on mandrel.
To unload accessory:
1. Pull spring-loaded sleeve DOWN toward
tool with one hand (Fig. 1).
2. Hold sleeve down while twisting accessory
90 degrees.
3. Remove accessory.
During use
Avoid damage to EZ lock™ mandrel by not
letting it contact the workpiece.
EZ Lock Operating Instructions
™
Always make sure the
rotary tool is "OFF"
FIG. 1
FIG. 2
FIG. 3
FIG. 4
FIG. 5
25