Parts Description - Makita EY403MP Manual De Instrucciones

Electrical and battery safety
1. Do not dispose of the battery(ies) in a fire.
The cell may explode. Check with local codes for
possible special disposal instructions.
2. Do not open or mutilate the battery(ies).
Released electrolyte is corrosive and may cause
damage to the eyes or skin. It may be toxic if
swallowed.
3. Do not charge battery in rain, or in wet
locations.
Do not charge the battery outdoors.
4.
5. Do not handle charger, including charger plug,
and charger terminals with wet hands.
6. Avoid dangerous environment. Don't use the
tool in dump or wet locations or expose it to
rain. Water entering the tool will increase the risk
of electric shock.
First Aid
1. In case of accident make sure that a first-aid
box is available in the vicinity of the opera-
tions. Immediately replace any item taken from
the first aid box.
When asking for help, give the following
2.
information:
— Place of accident
— What happened

PARTS DESCRIPTION

► Fig.1
1 Saw chain
4 Retaining nut
7 Guide bar cover
ASSEMBLY
CAUTION:
Always be sure that the motor is
switched off and the battery cartridge or the spark
plug cap is removed before carrying out any work
on the tool.
CAUTION:
Do not touch the saw chain with
bare hands. Always wear gloves when handling
the saw chain.
Removing or installing saw chain
CAUTION:
The saw chain and the guide bar
are still hot just after the operation. Let them cool
down enough before carrying out any work on
the tool.
CAUTION:
Carry out the procedure of install-
ing or removing saw chain in a clean place free
from sawdust and the like.
SAVE THESE INSTRUCTIONS.
WARNING:
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product.
MISUSE or failure to follow the safety rules stated
in this instruction manual may cause serious
personal injury.
WARNING:
dust containing chemicals which may cause
respiratory or other illnesses. Some examples of
these chemicals are compounds found in pes-
ticides, insecticides, fertilizers and herbicides.
Your risk from these exposures varies, depend-
ing on how often you do this type of work. To
reduce your exposure to these chemicals: work
in a well ventilated area, and work with approved
safety equipment, such as those dust masks that
are specially designed to filter out microscopic
particles.
2 Guide bar
5 Chain adjusting screw
- -
To remove the saw chain, perform the following steps:
1.
ing nut.
► Fig.2: 1. Chain adjusting screw 2. Retaining nut
2.
saw chain and guide bar from the tool body.
To install the saw chain, perform the following steps:
1.
direction of the saw chain with that of the mark on the
tool body.
2.
guide bar. Fit the other end of the saw chain around the
sprocket. Make sure that the saw chain is properly fitted
on the sprocket and properly fitted in the groove of the
guide bar.
3.
hole on the guide bar with the pin on the tool body.
► Fig.3: 1. Sprocket 2. Hole
4.
tool body, and then close the cover so that the bolt and
pin on the tool body meet their counterparts on the
cover.
► Fig.4: 1. Protrusion 2. Sprocket cover 3. Bolt 4. Pin
11 ENGLISH
— Number of injured persons
— Kind of injuries
— Your name
DO NOT let comfort or familiarity
Use of this product can create
3 Oil tank cap
6 Front grip
-
Loosen the chain adjusting screw, then the retain-
Remove the sprocket cover, and then remove the
Check the direction of the saw chain. Match the
Fit one end of the saw chain on the top of the
Attach the guide bar to the tool body, aligning the
Insert the protrusion on the sprocket cover to the
-