Time Setup; Alarm Setup - NGS SKY GAZER Manual De Instrucciones

USER'S MANUAL

TIME SETUP

When the speaker is connected to the power supply, the display
will show 00:00. To set the desired time, keep the loudspeaker
connected to the power supply but turned off.
1. Press TIME/ALARM. The numbers will flash.
2. Press the buttons repeatedly until the correct time is
selected.
3. Press TIME/ALARM again to confirm the time and the next 2
digits of the minute hand will flash.
4. Press again to select the minutes and then press
TIME/ALARM to save the time.

ALARM SETUP

This speaker can be used as an alarm.
1. Make sure the speaker is turned off.
2. Make sure you have set the time correctly.
4
3. Press and hold the TIME/ALARM button. The display will show
ON. Switch between ON and OFF with the
press TIME/ALARM again, when the display will flash.
4. Press to select the alarm time. Confirm by pressing
TIME/ALARM. Select the minute and press TIME/ALARM again.
5. Finally select CD/USB and confirm by pressing TIME/ALARM.
As a result, the speaker will start to play at the desired time in
the selected mode.
6. The volume will gradually rise from 0 to 20.
SLEEP MODE SETUP
Press and hold the SLEEP button until the display flashes. Press
again repeatedly until the desired time is selected. You can select
from 90 minutes to 10 minutes. It will flash 3 times to indicate
confirmation. If you want to cancel it, just repeat the process
and select "00".
button and