Klark Teknik DN32-DANTE Guia De Inicio Rapido página 10

18 KLARK TEKNIK DN32-DANTE
5.5 Two M32 consoles with DN32-DANTE
connection to DVS for recording
64 simultaneous tracks
• •
Both consoles need to have DN32-DANTE cards installed.
Connect one of the DN32-DANTE Ethernet ports on console A
with the card installed in console B.
• •
Connect the second port of console B, either directly with
the DAW-PC/Mac or via a network router to which the DAW
has access. This link will carry all 64 channels to and from
both consoles.
Midas M32
Router
Console A
(optional)
Midas M32
Console B
Two M32 consoles with DN32-DANTE connection to DVS for recording 64 simultaneous tracks
• •
Tip: The console's Ethernet remote control can be done
over the same network. For remote controlling console A
in this example, it is suffi cient to use a short patch cable
connecting console A's Remote connector with the free port
on DN32-DANTE. Since both ports on DN32-DANTE of console
B are occupied already, you would need to patch a separate
cable to the network router.
• •
Open the Dante Virtual Soundcard driver control panel and
switch it ON.
• •
Run the Dante Controller application to confi gure the virtual
channel patch bay and route the channels between Dante
Virtual Soundcard and the consoles.
Laptop/DAW
6. Mixer Setup
The following four M32 screens have to do with confi guring the
DN32-DANTE and the signals to/from the card.
• •
The SETUP/card screen shows a graphic of the DN32-DANTE
card when it has been installed correctly, and off ers advice
on setup.
• •
The SETUP/confi g page selects the synchronisation source
and shows status indicators in the top 'global' area
(which should normally be "C" for DN32-DANTE Card).
• •
The ROUTING/home page allows patching of signals from the
DN32-DANTE card to the Input Channel processing.
(e.g. channel 1-4 on Aux In)
Quick Start Guide 19