Klark Teknik DN32-DANTE Guia De Inicio Rapido página 11

20 KLARK TEKNIK DN32-DANTE
• •
The ROUTING/card out page selects channel blocks that will
be provided to the Dante network controller. (e.g. 8 Local
Outputs and 3 x 8 signals from AES50 Port A)
Note that the Dante network routing must be confi gured
exclusively using the Dante Controller Application for Mac/PC.
The signals that have been routed from the Dante Controller App
to the DN32-DANTE card are available for patching to the input
channel routing on the console's Routing/Home page. Please
Synchronisation
A master word clock source must be selected for the network.
The DN32-DANTE Brooklyn II VCXO clock off ers extremely
low-jitter. In this case the Setup/Confi g page should look like this:
Note that the status bar shows "C: 44K1" and a green light for
proper synchronisation of 44.1 kHz to the card.
The second green light "C: Dante" indicates proper installation of
the DN32-DANTE card. The Dante Controller app confi gures the
network for using the DN32-DANTE VCXO clock in this application.
refer to audinate.com for a comprehensive set of documentation,
FAQ and forum advices on confi guring the Dante Controller and
Dante Virtual Soundcard applications.
See the M32 line, which is confi gured for Clock Status Master in
the following example:
Note that the check boxes for 'Slave to External Word Clock' are
unchecked in this application.
Alternative Synchronisation:
Use the internal clock as master clock. In this case the
Setup/Confi g page should look like this:
Note that the status bar shows "L 44K1" and a green light for Local
(internal) clock of 44.1 kHz.
The second green light "C: Dante" indicates proper installation of
the DN32-DANTE card.
Quick Start Guide 21