MO-EL PETALO Uso Y Mantenimiento página 8

Ocultar thumbs Ver también para PETALO:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 18
• Upright mounting (code 702, optional). Ensure that the slots in the support (cod.
003205, optional) are located at its lower end (Fig. 4 and Fig. 4-A), and the arrow on the
label is turned up (Fig. 5).
The wall/pole bracket (code 003205, optional) allows the mounting of the appliance in either
perpendicular or tilted position. In the first case, fix the two parts of the bracket by the
screws on the 4 holes at the side; in the second, fix the two parts of the bracket by the
screws on the upper 2 holes at the side and 2 slots below. (See Fig. 6).
Use only the upright "Totem" that can be ordered as accessory (cod. 702).
Ensure that the power cable cannot come into contact with the reflector of the
appliance and does not intrude into the area of light flux.
4. USE
The Petalo range consists of a 1200 W heater and an 1800 W heater. The essential element
of the heater is the halogen filled quartz linear lamp with a tungsten element. The heater op-
erates at full output almost immediately. The heating reaches a distance of about 3 meters
in front of the appliance.
Avoid exposing skin to the rays of the appliance for distances less than 50 cm.
Avoid exposing eyes to the rays of the appliance for distances less than 2.70 m.
All users should be made aware of all aspects of operation and safety and these
instructions should be retained for reference.
• Switch on the heater (in the models that have the switch. Fig 1-A).
• Ensure that the rays of the heater are directed towards the area it is wished to heat. If
necessary, change the angle of inclination by loosening the support screws.
• Do not use the heater directly near a bathtub, a shower, a swimming pool.
• In unoccupied premises it is recommended that the heating system is switched off and
isolated from the electrical supply.
5. MAINTENANCE
Mo-El Petalo heaters contain no moving parts and therefore very little maintenance is re-
quired other than to ensure that there is no excessive build-up of dust/dirt on the reflectors
or emitters as this can cause overheating and premature emitter failure. To clean the appli-
ance, wipe off with a damp cloth.
The accumulation of limestone or incrustations reduces the life and the efficiency of the
lamp; it is suggested therefore to avoid the continued use in presence of water or salt fog.
Eventual leavings of salt water will have to be removed before the use, after having discon-
nected the appliance, by means of soak in sweet water.
6. EMITTER AND SILICON BUMPERS REPLACEMENT
The emitters used in the Petalo are robust and if knocks and shock vibrations are avoided,
they will last for around 5000 hours. When changing the lamp, also the silicon bumpers con-
8

Publicidad

Tabla de contenido
loading

Tabla de contenido