Lip Sync - Q Acoustics m2 Manual De Instrucciones

9.3. Going out of range
When a Connected device goes out of range, the Unit will remain on the Bluetooth
device returns in range it will automatically re-connect to the Unit. In many cases Play must be pressed
on the device to resume audio playback. Whilst out of range, the Unit source can still be changed using
the SOURCE SELECT button or by turning on a higher priority source.
Please Note: If the Bluetooth
automatically go into STANDBY.
9.4. Pairing more than one Bluetooth
The Unit can have up to eight Bluetooth
details of the first device will be lost.
Once the Unit is connected with a device, it will stop automatically searching for other devices to Pair with
or Connect to. To Connect to another device, either Disconnect the currently connected source on the
device itself or press the Bluetooth
9.5. Coming out of standby
If there is a Paired device in proximity to the Unit when it comes out of STANDBY it will automatically
initiate a connection to the device. It will not switch to Bluetooth
10. MoviEQ
™
MoviEQ is Q Acoustics' preferred balance to maximize the excitement and drama from your TV and
™
Movie viewing.
MoviEQ is simply toggled On or Off by pressing the Remote Control EQ button. The LED will indicate
™
whether MoviEQ is turned on by a flash pattern shown below:
™
Yellow flash x 2 + yellow = MoviEQ
Yellow flash x 2 + red = MoviEQ

11. Lip Sync

The Unit has a lip sync feature for its HDMI
added to the audio for synchronisation with a screen. When in Lip Sync mode, the lip sync is adjustable
in 10ms steps using the Vol + and – buttons.
To enter Lip Sync mode simply double tap the Bluetooth
The lip sync time is then adjusted and displayed by the following flash pattern, the LED will maintain the
colour of the currently selected source:
0ms = 2 flash
10ms = 4 flash
20ms = 6 flash
30ms = 8 flash
40ms = 10 flash
50ms = 12 flash
After 30 seconds of no other button presses the Unit will exit Lip Sync mode and return to normal
operation. You will only have to set the Lip Sync once as the Unit remembers the delay times for both
HDMI and Optical separately.
™
source does not come back into range for 20 minutes the Unit will
®
device
®
devices in its Pairing list. When you Pair with the 9th device the
®
Pair button on the Rear Panel of the Unit.
®
On
™
Off
™
and Optical inputs. This allows up to 50ms of delay to be
™
19
input until Play is pressed on the device.
®
Pair button on the Rear Panel of the Unit.
®
channel. When the
®