Pty (Program Type) Button; Power Button - Elta 7538N Manual De Instrucciones

01-7538N-GE-EN 7/29/06
• Temporarily switch over to an EON linked station when EON detects a traffic announcement on that other
program, and TP will be displayed on LCD
• If volume level is below 20, volume level is raised to 20, and returns to its previous mode and volume level
when the traffic announcement is over.
If volume is adjusted during traffic announcement, only the traffic announcement volume is valid.
* TA interruption function:
The current traffic announcement is cancelled by pressing this key. But the TA mode will not be off.
* When TA is on, SEEK, (SCAN), AUTO MEMORY function can be received or saved only when traffic
program identification code has been received.
When TA is ON, traffic program identification code is not received during specified time.
(2) When pressed long, it is selected EONTA LOCAL/EONTA DISTANCE mode. The purpose of this key is to
reduce unwanted EON TA switching, which EON TA Information was received from current station and the
radio switched to that EON linked station, but no information could not be received because the EON linked
station is located too far from that area. So the radio is switched back to current station again. In above
operation, a customer listen to a wrong program or mute sound for a while.
• EONTA LOCAL mode:
When the filed strength level of EON linked is less than the threshold level, the radio does not switch that
station, and a customer can hardly listen to any disturbances.
When EONTA LOCAL mode is selected, EONTA LO on numeric display is indicated for a few seconds.
• EONTA DISTANCE mode:
EON TA switching is try to implemented by the information of current station. When EONTA DISTANCE
mode is selected, EONTA DX on numeric display is indicated for a few seconds.

8. PTY (PROGRAM TYPE) BUTTON

Press it shortly and repeatedly to select one of the following mode:
PTY MUSIC group - PTY SPEECH group - PTY OFF
While selecting PTY TYPE, its selection is implemented by preset buttons as described in preset key (Press one
of the 6 preset buttons shortly and repeatedly to select the PTY TYPE in the preset button). When PTY MUSIC or
PTY SPEECH is on, the previous PTY program and PTY word is displayed on LCD. If there are no keys entered
for 2 seconds, previously selected PTY is searched. During 1 loop, if desired PTY is not found, NO PTY is flashed,
then return to previous normal radio and PTY word disappear.

9. POWER BUTTON

Press any button except the EJECT and RELEASE button to turn on the unit.
It also can turn on the unit to insert disc, MMC/SD card or USB bar into their compartment or socket.
Press PWR button hold for more than 0.5 seconds to turn off the unit.
10. AF [ALTERNATIVE FREQUENCIES] BUTTON
When pressed short, AF switching mode is selected and the state of AF switching mode is displayed by AF
segment in display.
Segment off: AF switching mode off.
Segment on: AF switching mode on, and has RDS information.
Segment flashing: AF switching mode on, but RDS information is not received yet.
When AF switching mode is selected, the radio checks the signal strength of AF all the time. The interval of
checking time of each AFs depends on the signal strength of current station, from a few minute for strong station
to a few seconds for weak station. Every time that new AF is stronger than current station, it switches over to that
frequency for very short time, and NEW FREQUENCY is displayed for 1-2 second. Because the mute time of AF
switching or checking time is very short, it is almost inaudible in case of normal program.
During FM mode, when AF is on, SEEK, (SCAN), AUTO-MEMORY function can only receive and save RDS
program.
018.
11:45 AM Page 018