Using The Front Panel; Working Principle - Worldcast Systems ECRESO FM 5kW Guía Rápida

2. Setting the transmitter power and inputs
To configure the transmitter using the front panel: see section 3.
To configure the transmitter using the embedded web site: see section 4.
To use serial commands, see the user manual, chapter 7.

3. Using the front panel

3.1

Working principle

The key pad on the right of the screen allows you to browse through the menus:
If the screen is in standby mode, touch any key to reactivate it.
Arrows are used for
scrolling through menus,
selecting parameters and
adjusting values.
LEDs indicate possible
directions, for instance,
only up and down arrows
are available when scrolling
through main menus.
When adjusting values,
press on the top or down
button for small
increments or swipe your
fingers around for large
increments
!
The transmitter must be in local mode before parameters can be modified. Press the
Local button if needed.
The front panel is available in either French or English. To change the language:
From the main screen, press the Check button to
display menus then the down arrow until you see
the About/System menu.
Once you see this screen, press the Check button
Use the down arrow to select the language. Press
the Check button to switch to edit mode, the
down or up arrow to change the language, the
Check button to confirm your choice.
Press the Return button to return to the list of
menus.
English version
The Check button is used
to:
• Access a lower level menu
• Enable the edit mode for
parameters that can be
modified,
• Confirm a new value.
The Return button is used
to
• Return to the higher level
screen,
• When in edit mode, go
back to the initial value.
5