Control Button - Axis Q3517-LVE Guia De Instalacion

Buttons

Control button

For location of the control button, see Product overview on page 8.
The control button is used for:
• Resetting the product to factory default settings. See page 22.
• Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic DNS
Service. For more information about these services, see www.axis.com.
Function Button
The function button has multiple functions:
• As leveling Assistant – This function helps to ensure the image is level. Press the button
for about 2 seconds to start the leveling assistant and press again to stop. The status
LED (see ) and buzzer signal assist leveling of the image. The image is level when the
buzzer beeps continuously.
• To view the Status LED – Press the button once to light up the Status LEDs. Press again
to turn them off. The LEDs will turn off automatically after 10 seconds.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO NO TICE NO TICE TICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic compatibility (EMC) 4.
Audio connector
The Axis product has the following audio connectors:
• Audio in (pink) – 3.5 mm input for a mono microphone, or a line-in mono signal.
• Audio out (green) – 3.5 mm output for audio (line level) that can be connected
to a public address (PA) system or an active speaker with a built-in amplifier. It is
recommended to use a stereo connector for audio out.
AXIS Q3517–LVE Network Camera
25
EN