Usage As A Starter; Usage As A Charger (Recharge Of Internal Batteries) - GYS PACK PRO 12.24 Manual Del Usuario

Using your GYSPACK PRO as a starter
• Unplug the socket from the mains.
• Disconnect the voltage selector, and turn the battery-switch on OFF.
• Plug the red clamp to the (+) and the black clamp to the (-).
NB: In the event of polarity inversion, Gyspack Pro 12-24 will sound a buzzer
and a show a red led warning.
• Connect the voltage selector on 12V or 24V depending on the battery of the
vehicle you wish to start.
• Turn the battery switch on ON
• Turn the key of your vehicle in order to activate the start function
NB : if the vehicle does not start, wait 3 minutes between attempts to start
A vehicle which does not start after the third attempt probably has a problem
unrelated to the battery: alternator, spark plug,...
• Once the vehicle has started, turn the battery switch on OFF.
After a start or a high consumption of batteries, the red light will flash to
warn you that internal batteries should be recharged.
• Disconnect the voltage selector from the 12V or 24V socket.
• Unplug the black clamp then the red clamp from the vehicle.
• Connect the GYSPACK on a 230V 50/60Hz socket to recharge the batteries.

Usage as a charger (recharge of internal batteries)

In order to have your GYSPACK Pro fully operational and to ensure maximum output power, it
is advised to charge it after each use, and leave it charging until its' next use.
Gyspack Pro includes a high quality automatic charger, which will recharge its 2 batteries to a
100% charge, monitoring is not necessary and a maximum charge will be maintained due to
the advanced charging cycle (Floating System).
• Turn the battery switch on OFF and disconnect the clamps from the vehicle.
• Plug the voltage connector on the 12V socket.
WARNING: If you do not plug the 12V socket, the charge process won't start
(the leds will light for a short moment)
•
Connect the charger to a 230V 50/60Hz socket.
GYSPACK PRO 12.24
8