numskull PRO RACING WHEEL & PEDALS Manual De Instrucciones página 6

• R 3
• Gearshift +
• Gearshift -
Programming procedure
• Press simultaneously the OPTIONS and SHARE buttons for 3 seconds. The LED will
be lit in orange.
• Then press any of the 8 programmable keys ( listed above ) to set up a new function.
The LED will flash orange.
• Finally press the button that you would like to reassign to the programmable key. The
LED tuns red again, the key is now programmed.
• Repeat the above steps to program other buttons if necessary.
Reset one programmed key
• Press simultaneously the OPTIONS and SHARE buttons for 3 seconds. The LED will
be lit in orange.
• Then press on the programmed key that you would like to reset. The LED will flash
orange.
• Press the same button again. The LED tuns red again, the key is now reset to default.
Reset all the programmed keys
• Press simultaneously the OPTIONS and SHARE buttons for 3 seconds. The LED will
be lit in orange.
• Press again simultaneously the OPTIONS and SHARE buttons for 4 seconds. The
LED tuns red again, all keys are now reset to default.
You can also unplug the wheel for resetting the configuration.
6. Sensitivity adjustment
The sensitivity control is designed for a better steering control adapted to the different
types of racing game environments, such as Off-Road, Grand Prix racing, etc. To adjust
the sensitivity, move the switch located on the left of the steering wheel.
• Low sensitivity: put the switch on LO.
Steering angle is normal, adapted to most of the racing games
• Medium sensitivity: put the switch on MID.
Steering angle is small, good for quick turns racing games
•High sensitivity: put the switch on HI.
Steering angle is very small, good for very quick turns, corner turning, etc.