Rowenta DA1510 Manual Del Usuario página 6

1103903520 - DA1510:Mise en page 1
Note !
Make sure the iron is cold before storing it.
Do not use any cleaning or descaling products.
IMPORTANT Do not wind the cord around the hot soleplate.
Never store your iron placed down on the soleplate.
Storing your iron
Problems
and possible causes
• The temperature selected is too low.
• The steam control is set on OFF.
• There is no water in the tank
Water is dripping from the holes in the soleplate
• You have been using the burst of
steam button too often.
• Steam is used before the iron is
hot enough.
• The iron is stored with water in the
tank.
• The problem persists.
HELPLINE:
if you have any product problems or queries, please contact our Customer Relations
Team first for expert help and advice:
or consult our website - www.rowenta.co.uk
24/09/08
NO
Your iron produces little or no steam
Set the temperature control on •••
Switch the steam control to ON.
.
Fill the water tank.
Wait a few seconds between each shot.
Set the thermostat within the
coloured steam zone and wait until
the iron is hot (approx. 2 min.)
Empty the tank before storing the
iron and set the steam control to OFF.
Take your iron to an Approved
Service Centre.
0845 602 1454 - UK
(01) 677 4003 - Ireland
14:45 Page 6
10 min
Solutions