YATO YT-09695 Manual Original página 14

Defect Possible solutions
The tool starts and then The compressor does not provide the correct air supply. The tool operates by the air collected in the compressor tank. As the tank
releases. gets emptier, the compressor has not kept pace with the refi lling of air shortages. Connect the tool to a more effi cient compressor.
Ensure that the hoses have an internal diameter of at least such as specifi ed in the table in point 3. Check the set point of pressure,
Insuffi cient power whether it's set to the maximum value. Ensure that the tool is properly cleaned and lubricated. In case a lack of results, forward the
tool for repair.
Spare parts
For a detailed list of spare parts for the appliance go to the "Download" section in the Product tab on the TOYA SA website:
www.toya.pl.
After fi nishing work, the casing, ventilation slots, switches, additional holder and covers should be cleaned, for example, with a
stream of air (at a pressure not exceeding 0.3 MPa), with a brush or a dry cloth without the use of chemicals and cleaning liquids.
Clean tools and holders with a dry, clean cloth. Used tools are secondary raw materials - do not dispose of it in household waste
containers because it contains hazardous substances to human health or the environment! We ask for active help in the economi-
cal management of natural resources and protection of the natural environment by forwarding the worn tools to the point of storage
of worn equipment. To reduce the amount of disposed waste it's necessary to re-use them, recycle or recover in another form.
O R I
14
G I N A L I
GB
N S T R U C T I O N S