Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do not
touch the moving blade. There
is a risk of injury.
Level gauge
The level gauge (
side of the grass collection box. The aero-
dynamic air guidance provided by the flap
also optimises the filling.
Flap open:
grass catcher empty
Flap closed:
grass catcher full
Adjusting the Cut Height
Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
60 mm - Tall cutting height
40 mm - Medium cutting height
20 mm - Short cutting height
1. Place the lawnmower on its side.
2. Grasp the wheel axle (25) on both
sides.
3. Pull evenly on the axle and let it snap
into the desired position.
The correct height is around 20 – 40 mm
for a decorative lawn and around
40 – 60 mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.
74
8) is located on the
Working with the Lawnmower
Regular mowing encourages increased
foliation of the grass and kills off weeds at
the same time. Therefore, not only does
each mowing increase the density of the
lawn, it also produces an evenly resilient
lawn.
When mulch mowing the grass is cut in
one cycle, finely chopped and distributed
on the lawn. The cut grass acts as a natu-
ral fertilizer.
•
Start mowing near the socket and
work away from the socket.
•
Always keep the extension cable be-
hind you and when you turn, move it to
the side that has already been mowed.
•
Run the equipment at a walking pace,
in tracks that are as even as possi-
ble. For gap-free mowing, the tracks
should always overlap by a few centi-
metres.
•
On slopes, always work across the
slope. Take particular care when going
backwards and pulling the equipment.
•
Clean the equipment after each use,
as described in the chapter on "Clean-
ing, Maintenance and Storage".
Switch off the equipment after
work and in order to transport it,
disconnect the plug and wait until
the blade stops. There is a risk of
injury.
Cleaning/Maintenance
Have work that is not described
in these instructions carried out
by a customer service centre
that we have authorised. Use
only original parts.
Publicidad
Capítulos
Tabla de contenido
