General Cleaning And Maintenance Work; Changing The Blade; Storage; Waste Disposal And Environmental Protection - Deltafox DG-ELM 133 Traducción Del Manual De Instrucciones Original

Wear gloves when handling the
blade
Switch off the equipment before all
maintenance and cleaning work,
disconnect the plug and wait until
the blade stops.
General Cleaning and Mainte-
nance Work
Do not hose down the lawnmow-
er with water. This would result
in the danger of an electric
shock and the appliance could
be damaged.
• Always keep the equipment clean. To
clean, use a brush or cloth but no de-
tergent or solvent.
• After mowing, use a piece of wood
or plastic to remove adherent plant
remains from the wheels, ventilation
holes, ejection hole and blade area.
Do not use hard or pointed objects, as
these may damage the blade.
• Oil the wheels from time to time.
• Before each use, check the lawnmow-
er for obvious defects such as loose,
worn or damaged parts. Check that
all nuts, bolts and screws are sitting
firmly.
• Check the covers and protective de-
vices for damage and check that they
are sitting correctly. Replace them if
necessary.

Changing the Blade

Switch off the equipment before all
maintenance and cleaning work,
disconnect the plug and wait until
the blade stops.
If the blade is blunt, it can be sharpened
by a specialist workshop. If the blade
is damaged or showing signs of imbal-
ance, it must be replaced (see chapter on
"Spare Parts").
1. Turn the equipment over.
2. Turn the blade screw (24) anticlock-
wise off of the motor spindle using a
screwdriver.
3. Install the new blade in the reverse
order. Ensure that the blade is posi-
tioned correctly and the screw tight-
ened firmly.

Storage

For the device to take up less
space, unlock the quick-release
levers (2+4) on the bow-type han-
dle (1) and the lower bars. You can
now fold up the bow-type handle
(1) and the lower bar (4). Make
sure that the cables do not be-
come trapped.
• Keep the equipment dry and out of
reach of children.
• Allow the motor to cool before storing
the equipment in a confined space.
• Do not cover the equipment with nylon
bags as moisture could build up.
We will not be liable for damages caused
by our equipment where these are caused
by improper repair or the use of non-
original parts or by use other than for the
intended purpose.
Waste disposal and envi-
ronmental protection
Do not dispose of used oil in the sewage
system or drains. Dispose of used oil in
GB
75