Stid ARC Serie Manual De Instrucciones página 4

13.56 MHz
Upgradable readers ARC
Installation instructions
Clips
Slots
- Disconnect the flat flexible antenna cable from connector J6.
- Remove the core from the front part (steps 1, 2).
- Install the core in the keyboard front part.
- Connect the flat flexible antenna cable to connector J6 and the
flat flexible keyboard cable to connector J7.
Disconnect the flat flexible antenna cable of connector J6.
-
- Remove the core from the front part (steps 1, 2).
- Install the core in the screen front part.
- Connect the flat flexible antenna cable to connector J6 and the
screen ribbon to connector J14
© STid - 20 PA des Pradeaux FR13850 Gréasque - NI1097C13 - Page 3 sur 12 - Ed. 08/04/2019
13,56 MHz
Lecteurs évolutifs ARC
Notice d'installation
Dimensions
Steps to remove the core from the front cover
Step 1
Procedure to install the core into the front part
Place the core between the two slots at the top
of the cover.
Procedure to change the front part
.
13.56 MHz
Lectores escalables ARC
Procedimiento de instalación
conforme con NOM-024 -SCFI-2013
Step 2
Do not use the buzzer as a lever
And then pivot the core and press to insert it
between the two clips.
- Disconnect the flat flexible antenna cable from
connector J6 and the flat flexible keyboard cable
from connector J7.
- Remove the core from the front part (steps 1, 2).
- Install the core in the screen front part.
- Connect the flat flexible antenna cable to
connector J6 and the flat flexible screen cable to
connector J14
.
US
FR
ES