Blaupunkt 5IE64252 Instrucciones De Uso página 60

Installation
Insertion dimensions:
5IE64252
5IE84252
5II84251
5II94291
5IB64211
5IZ34291
• The distance from the cut-out to a wall and/or a piece of furniture must be at least
40 mm.
• This appliance complies with type Y with regard to protection against fire hazards. Only
appliances of this type may be installed on one side of adjacent tall cupboards or walls.
Caution: no furniture or appliances may be higher than the hob from the other side.
• The worktop must be finished with heat-resistant adhesive (75 °C).
• The wall edging strips must be heat-resistant.
• The hob must not be installed above stoves without fans, dishwashers, washing or drying
appliances.
• To ensure adequate ventilation of the electronics in the hob, an air gap of 20 mm is required
under the cavity.
• If there is a drawer under the hob, no flammable objects, e.g. aerosol cans, may be stored in
the drawer.
• The safety distance specified by the manufacturer must be maintained between the appliance
and an extractor hood. If not specified, this distance must be at least 650 mm.
• It must be ensured that the connection cable of the hob is not exposed to any mechanical
stress after installation, e.g. by a drawer.
• The cutting surfaces of worktops should be sealed with special paint, silicone rubber or casting
resin to prevent swelling due to moisture. Ensure that the sealing tape supplied is carefully
applied.
• Never glue the hob with silicone! It will then no longer be possible to remove the hob later
without destroying it.
• Do not use any unsuitable safety grilles or protective devices for the hob. This can lead to
accidents.
A B
590 mm 520 mm
780 mm 520 mm
780 mm 520 mm
880 mm 520 mm
590 mm 520 mm
300 mm 520 mm
E
560 mm
750 mm
750 mm
810 mm
560 mm
270 mm
28
F H
490 mm 52 mm
490 mm 52 mm
490 mm 52 mm
490 mm 52 mm
490 mm 52 mm
490 mm 52 mm