VONROC LM502AC Traducción Del Manual Original página 8

EN
e) Do not use a battery pack or tool that is dama­
ged or modified. Damaged or modified batteries
may exhibit unpredictable behaviour resulting in
fire, explosion or risk of injury.
f) Do not expose a battery pack or tool to fire
or excessive temperature. Exposure to fire or
temperature above 130 °C may cause explosion.
NOTE The temperature „130 °C" can be replaced
by the temperature „265 °F".
g) Follow all charging instructions and do not
charge the battery pack or tool outside the
temperature range specified in the instructions.
Charging improperly or at temperatures outside
the specified range may damage the battery and
increase the risk of fire.
6) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
ADDITIONAL SAFETY INSTRUCTION FOR
LAWN MOWERS
• Only use this lawn mower when a Residual
Current Device (RCD) with a tripping current of
not more than 30mA is in the circuit.
• If an extension cord is used make sure it is for
outdoor use and marked as such. The recom-
mended size of extension cord is a H05VV-F or
H05RN-F type, not lighter than 1.5 mm² and a
maximum of 10 metres in length.
• Completely uncoil your extension cable before
use to prevent overheating and loss of mower
efficiency. When tidying away the cable, wind it
carefully to avoid kinking.
• This appliance is not intended for use by per-
sons (including children) with reduced physical,
sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for
their safety. Children should be supervised to
ensure that they do not play with the appliance.
WARNING: After switching off the machine,
the cutting blade continues to rotate for a
few more seconds.
• Frequently inspect the condition of the cutting
blade. Damaged blade must be replaced im-
8
mediately. Follow all the required precautions
when replacing the blade.
• Before use check the supply and extension
cord for signs of damage or ageing. If the cord
becomes damaged during use, disconnect the
cord from the supply immediately.
• DO NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
• Not to connect a damaged cord to the supply or
touch a damaged cord before it is disconnected
from the supply. A damaged cord can lead to
contact with live parts.
• Do not use the mower if the cord is damaged or
worn.
• Read the instructions carefully. Be familiar with
the controls and proper use of the equipment.
• Keep extension cord away from cutting blades.
• Wear eye and ear protection. Wear dust protec-
tion if the mowing action causes the raising of
dust or particles.
• Never allow children, infirm people or people un-
familiar with these instructions to use this mower.
• Avoid using the mower while people, especially
children and the infirm, or pets are nearby.
• Use the mower only in day light or good artificial
light.
• Never operate the mower with a damaged base.
• When starting up and when the machine is in
operation, keep the cutting section away from all
parts of the body, especially the hands and feet.
• Do not start the machine when it is not in the
operating position. Do not start the machine
when standing in front of the discharge opening.
• Thoroughly inspect the mower for loose or
damaged parts before each use. Do not use the
unit until adjustments or repairs are made.
• Use only the manufacturer's recommended
replacement parts and accessories.
• Always disconnect the mower from the mains
when leaving it unattended.
• Switch the motor off and pull out the plug when
the machine is not being used, being cleaned,
being moved from one place to another or when
the blade is being changed or adjusted.
• If there is an interruption to the power supply or
the extension cable is damaged, switch off the
machine immediately and remove the plug from
the power point.
• Inspect and maintain the mower regularly.
Have the mower repaired only by an authorised
repairer.
WWW.VONROC.COM