Master Trimmers MT Professional 50 Manual De Uso Y Mantenimiento página 33

With Allen key No. 5 (P) loosen, without removing, the two side
6
bolts shown in the following image, and repeat the same process
with the two bolts on the opposite side.
Replace the protection grid and fix it with the help of the four latches. Screw in or unscrew the threaded studs to raise or lower the blades as
8
required. Measure the distance between the two ends of the blades and the grid with a caliper or other measuring instrument as shown in
the following image.
If the distance is not the same, it will be necessary to adjust the height, screwing or unscrewing the threaded studs, as
appropriate.
Once the blades are levelled, remove the grid and fix the two side
9
bolts on both sides with the help of Allen key No. 5 (P), as shown in
the following image.
Replace the protection grid and fix it with the help of the four
11
latches.
The red coloured support in the following image has been
7
released and is free to move. Screwing or unscrewing the four
threaded studs on it and enabled for this purpose allow the blades
to be levelled, but before doing that, the grid must be placed as
described in the next step.
=
=
Next, tighten the four nuts shown in the following image, using the
10
Allen key No. 3 (N) and fixed spanner No. 10.
Finally, replace the container and fix it with the help of the two
12
retaining knobs (F).
www.masterproducts.es
=
=
33