Installing The Controller - Autopilot PPM-5 Manual De Instrucciones

OVERVIEW
Thank you for purchasing the Autopilot PPM-5 CO
and affordable way to control your CO
(PPM) level and the controller will automatically maintain that specified CO
located on the right side of the sensor automatically deactivates CO
remote sensor with 16' cable allows close placement to the plant canopy.

INSTALLING THE CONTROLLER

1. Plug the unit into a standard NEMA 5-15 120V wall outlet. Place the remote sensor probe in a
well-ventilated area at plant height.
2. Plug the CO device into the power outlet on the front of the controller. Ensure that the CO
2
has the proper voltage (120V) and will not exceed the maximum amperage rating of the unit
(15A).
READING CO LEVELS
2
1. Allow the unit to warm up for approximately 5 minutes.
2. The display on the unit will report the current CO
of the APCECO2 unit (marked "ON") will illuminate when the outlet on the front of the unit is
energizing the CO
illuminated) during the dark period (when the photocell senses darkness).
www.Hydrofarm.com
2
INSTRUCTIONS
injection device. Choose your desired CO
2
injection device, and will blink during calculation times. It will be off (not
2
Controller. The CO
2 2
injection during the night time. A
2
levels (as PPM). The green LED on the front
2
monitor & controller is a simple
parts per million
2
level. A built-in photocell
2
device
2