NGS SKY CHARM Manual De Instrucciones página 5

ENGLISH
PLUG 2 INTO STEREO
• Plug the second NGS Skycharm speaker into the main one
using a 3.5mm jack cable. Plug one end of the audio cable into
the output port of the main speaker, which is located on the
rear panel, and the other end of the cable into the input port
of the secondary speaker (also at the rear).
• Control all functions from the main speaker.
Important
If you plug an audio cable into the audio input on the rear panel
without the other end of the cable being connected to a speaker,
the tower automatically shuts down and must be turned on
again.
OPTICAL INPUT MODE
• Plug one end of the optical cable into your TV, make sure it
is turned on and plug the other end into the NGS Skycharm
speaker. The display will show "OP".
Note: You must select the optical audio output from the TV so
that the sound signal reaches the speaker.
FM MODE
• Select FM mode.
• Press and hold the PLAY / PAUSE button for two seconds to
automatically search for available stations. Press again to
discontinue and store the searched stations.
• Press and hold the NEXT or PREV keys to switch channels.
• Press the NEXT or PREV keys to increase or decrease the
frequency by 0.1 MHz each time and select the desired station.
• Press the FM key to save the selected station.
Note: channels are automatically assigned and sorted by
ascending frequency.
5