Maintenance And Cleaning; Technical Data - Batavia MAXXPACK 18V Manual Del Usuario

English
• If using saw blades not designed for cut-
ting metal, ensure there are no nails or
screws embedded in the workpiece. If
necessary, remove embedded objects or
use metal cutting saw blades instead.
Sanding
• The removal rate and the sanding pattern
are determined by the type of sanding
sheet, the preset oscillation rate and the
applied pressure.
• Pay particular attention to applying uni-
form sanding pressure; this increases the
working life of the sanding sheets.
• Intensifying the sanding pressure will not
lead to an increase of the sanding capac-
ity, but to increased wear of the machine
and prema-ture wear of the sanding sheet.
• For precise on-the-spot sanding of edges,
corners and hard-to-reach areas, it is also
possible to work only with the tip or an
edge of the sanding plate.
• A sanding sheet that has been used for
sanding metal should not be used for
sanding other materials.
• Regularly brush down or vacuum the
surface being sanded to ensure the sand-
ing sheet is in direct contact with the
surface.
Scraping
For scraping, select a high speed setting.
On soft surfaces (e.g. wood), work at a flat
angle and apply only light pressure so that the
scraper does not cut into the surface.

MAINTENANCE AND CLEANING

WARNING: Always disconnect from the mains
power supply, before carrying out any mainte-
nance/ cleaning of the charger. Remove the
battery before carrying out any maintenance/
cleaning of the tool.
Maintenance
There are no inner parts of the tool which need
maintenance.
Cleaning
• Keep safety devices, ventilation openings
and the motor housing as free as possible
from dirt and dust. Rub the electric power
8
tool with a clean cloth or blow over it with
low pressure compressed air.
• We recommend that you clean your elec-
tric power tool immediately after each use.
• Clean the electric power tool regularly with
a damp cloth and somewhat soft soap. Do
not use any cleaning or solvent materials;
these can attack the device's plastic com-
ponents. Make sure that no water can get
inside the electric power tool.

TECHNICAL DATA

No Load Speed. . . . . . 5000 – 15 000 min
Oscillation Arc Range. . . . . . . . . . . . 3°
Dimensions . . . . . . . . . . 26 × 9 × 6.5 cm
Weight . . . . . . . . . . . . . . . . . 1.05 kg
Sound Pressure Level L
Uncertainty K . . . . . . . . . . . . . . 3 dB
pA
Sound Power Level L
WA
Uncertainty K . . . . . . . . . . . . . . 3 dB
WA
Hand Arm Vibration. . . . . . . . . 7.529 m/s
Uncertainty K . . . . . . . . . . . . . .1.5m/s
DISPOSAL
Do not dispose of electric power
tools with domestic refuse.
The electric power tool is shipped in
packaging to reduce transport damage. This
packaging is a raw material and as such can
either be reused or can be fed back into the
raw material cycle. The electric power tool and
its accessories are made from various materi-
als such as metals and plastics. Take defective
components to a special refuse collection
point. Ask about these at your specialist shop
or local council. The product and the user
manual may be subject to changes. Technical
data may be changed without prior notice.
Batteries
Think of the environment when disposing of
batteries. Contact your local authorities to find
out where your nearest disposal area is.
Do not dispose of batteries with domestic
refuse.
Do not dispose of by burning, risk of explosion.
. . . . . .77.77 dB(A)
pA
. . . . . . 88.77 dB(A)
-1
2
2