Genius G60 Guia De Inicio Rapido página 7

ENGLISH
8) Lift the sliding guide bringing the rear connection to the
same level as the front one, or, with sectional doors, until
reaching the same angle as the door horizontal rail. For
direct fixing to the ceiling, go to point 12, after modifying
the rear connection as indicated in par. 6.2.
9) Measure the distance between ceiling and the centre di-
stance of the rear connection fixing nuts.
10) Bend the brackets (supplied) to the measurement made
(measure from the centre of the first slot on the bracket).
11) Fit the brackets on the rear connection and reposition the
sliding guide (fig. 15).
12) Mark the fixing points on the ceiling, drill (taking care to
protect the sliding guide), position the front fixing bracket of
the operator (fig. 10 ref. C and fig. 15) and complete guide
installation.
13) If using a "two pieces sliding guide" with central connection
(fig. 16 ref. A) or the central support for single rail (fig. 16 ref. B
- optional), carry out ceiling fixing using the special brackets,
proceeding as described in steps 9,10 and 12 (fig. 16).
7.2. CONNECTION ON DOOR
1) Assemble the connection bracket with the carriage bar
(fig. 17).
If using the outside release device, position the connec-
tion bracket on the door so that the release wire loop is
turned towards the left side of the door (fig. 17 and 18).
2) Close the door and bring the carriage near it.
3) Position the connection bracket on the door centred with
the middle.
4) Check that the distance between centres of the door
connection and front connection bracket fixing holes is not more
than 20 cm (fig. 18). For correct working of the automatic
system avoid arm angles of more than 30° with respect to
the sliding guide.
If using the curved arm for sectional doors (optional) carry
out assembly with the straight arm of the carriage as indica-
ted in fig. 19. To improve the efficiency of the anticrushing
system it is advisable to fix the connection bracket on the
sectional door in the lowest position possible, but not more
than 40 cm from the front connection of the operator.
5) Mark, drill and fix the connection bracket to the door.
Fig. 15
Fig. 16
17
ENGLISH
Fig. 17
Fig. 18
Fig. 19