Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Figure 5
Starter
Table

HARDWARE INCLUDED

• (2) 3/8" x 3/4" Bolts
• (2) 3/8" x 3" Bolts
• (4) 3/8" Flange Nuts
ASSEMBLY OF ADD-ON TABLES
1.
Repeat steps on page 1 for leg assembly.
2. With the aid of a helper, align add-on table to
starter table. The holes on the underside of both
table tops should line up. Install (2) 3/8" x 3/4" bolts
and nuts through holes provided. (See Figure 5)
NOTE: To create a flat working surface between
tables, you may need to lift the corners of
add-on table when nuts are tightened.
NOTE: Lower Shelf does not require hardware to
assemble.
NOTE: Install shelf only after table has been
fully assembled and all bolts and nuts are
tightened.
1.
Position lower shelf underneath table and line up
with lower cross bar of each leg set. Place shelf over
cross bars. (See Figure 7)
PAGE 2 OF 9
ADD-ON TABLE ASSEMBLY
Starter Leg
Brace Bolt
3. Unfold remaining flat braces on add-on table
4. After all starter and add-on tables have been
SHELF ASSEMBLY
(2) 3/8" x 3/4" Bolts
and Nuts
Flat Brace
and line up with leg assembly on starter table.
Remove starter leg brace bolts. Install braces
from both tables to leg assembly using the
same starter leg brace bolts. (See Figure 6)
Figure 6
assembled, all nuts can be tightened fully.
Figure 7
Add-On
Table
Lower
Shelf Slit
Lower
Cross Bar
1021 IH-3630

Publicidad

Tabla de contenido
loading

Tabla de contenido