Enter And Exit Setup Mode; Setting The Co Upper Limit Of Good Level; Setting The Co Upper Limit Of Normal Level - Wohler CDL 110 Manuel De Instrucciones

Setup
7.1 Enter and exit
setup mode
7.2 Setting the CO
upper limit of
good level
Fig. 6: Setting P1.0: good level
Fig. 7: Setting the upper limit of the good
level.
7.3 Setting the CO
upper limit of
NORMAL level
Fig. 8: Setting the CO
NORMAL level
40
•
•
2
•
•
•
•
2
•
upper limit of
2
Press and hold SET under normal mode for
more than 3 seconds to enter the setup mode.
To exit setup mode, press ESC.
In the setup mode, CO
(see Abb. 6)
Press SET again to enter the P1.1 mode for
setting the CO
The current set value is blinking now (see Abb. 7).
Press ▲ to increase or MIN/MAX▼ to de-
crease the value.
Each press tunes 100 ppm.
NOTE!
The alarm range is from 0 to 700 ppm.
Press SET again to confirm the P 1.1 setting
and to enter the P 1.2 mode for the upper limit
of NORMAL level.
Press ESC (without pressing SET before) to re-
turn to P 1.0 without saving.
Press ▲ to increase or MIN/MAX▼ to de-
crease the value.
Each press tunes 100 ppm.
NOTE!
The alarm range is from 700 ppm to 1000 ppm.
Press SET again to confirm the P 1.2 setting
and to enter the P 1.3 mode for setting the
alarm level.
Press ESC (without pressing SET before) to re-
turn to P 1.0 without saving.
and P 1.0 are displayed.
2
upper limit of GOOD level.
2