Noise And Vibration - Felisatti RHF40/1100VERT Instrucciones De Servicio

3. Fit and adjust the side handle.
4. Pull the trigger switch and start working.
5. Push with only enough force to keep bit from bouncing.
Pressing very hard on the tool will not increase chipping
speed.
6. To stop the tool, release the trigger switch. Always turn
the tool off when work is inished and before unplugging
10. Operation time
The tools shall be operated intermittently as fallows;
- Operating time : 30 s
- esting time : 90 s
11.VCS (Multi Vibration
(RHF40/1100VERT, RHF40/1100VERTM)
The VCS function reduces occurring vibration.

NOISE AND VIBRATION

This tool has been designed and made to reduce
noise to a minimum. However, in spite of this, in certain
circumstances the maximum noise level in the place of
work could exceed 85 dBA. In this case, the operator
should wear ear protection.
Use ear protection!
WARNING! The vibration level given in these
instructions has been measured in accordance with
a standardized measurement procedure speciied in
EN60745 and can be used to compare devices. Different
uses of the device give rise to different vibration levels and
in many cases they may exceed the values given in these
instructions. It is easy to underestimate the vibration load
if the electrical power tool is used regularly in particular
circumstances.
Note. If you wish to make an accurate assessment of
the vibration loads experienced during a particular period of
working , you should also take into account the intervening
periods of time when the device is switched off or is running
but is not actually in use. This can result in a much lower
vibration load over the whole of the period of working.
ACCESSORIES
Accessories and their corresponding order number
can be found in our catalogues.
MAINTENANCE
1. Checking the Tool (bit)
Using the worn-off bit will cause overloading the motor
and reduce work eficiency. Either sharpen the tool or
replace with a new one.
2. Checking the Screws
Check if any screw is losen. Losen screw must be
fastened irmly.
Replacement of screw must be carried out at the
authorized A/S center using genuine parts. Otherwise
Commutator may worn out quickly shortening the service
life of the Tools.
3. Maintenance of Motor Assembly
The Commutator in the Motor Assembly is the core
part of the tool. Be careful not to cause scratch or contact
with oil or water on the surface of the Commutator.
4. Storing after Use
Store the tool in a dry place out of reach of the
children.
5. Repair
If the tool is not operating normally, do NOT attempt
to locate the problem or repair yourself. Contact nearest
authorized A/S center for service.
6. Cord
must be replaced by a specially prepared cord available
through the service organization.
attached sheet.
Control System)
relating to old electrical and electronic appliances and
its translation into national law, used electric tools must
be collected separately and recycled in an ecologically
desirable way.
If the supply cord of this power tool is damaged, it
WARRANTY
See general warranty conditions printed on the
DISPOSAL
WARNING! Do not dispose of electric tools in the
household waste!
In accordance with European Directive 2002/96/EC
7