Tabla de contenido
Publicidad
2.9 ASRock Smart Remote Installation Guide
ASRock Smart Remote is only used for ASRock motherboards with a CIR header.
Please refer to the procedures below for the quick installation and usage of ASRock
Smart Remote.
Step1.
Find the CIR header located next
to the USB 2.0 header on your
ASRock motherboard.
Step2.
Connect the front USB cable to the
USB 2.0 header (as below, pin 1-5)
and the CIR header. Please make
sure the wire assignments and the
pin assignments are matched
correctly.
Step3.
Install the Multi-Angle CIR Receiver to the front USB port.
Step4.
Boot up your system. Press <F2> or <Del> to enter the BIOS Setup Utility.
✁ ✂ ✄ ☎ ✆ ✝ ✄ ✞ ✟ ✄ ✠ ✡ ✞ ☛ ✠ ☞ ✌ ✍ ✎ ✏ ✍ ✠ ☞ ✞ ✝ ✠ ✑ ✑ ✄ ✝ ✌ ☛ ☎ ☎ ✄ ✞ ✞ ✠ ✒ ✓ ☞ ✁ ✔ ✑ ✄ ✕ ✖ ✗
✘ ✙ ✕ ✚ ✁ ☞ ✛ ✄ ✕ ✜ ✢ ✣ ✆ ✡ ✄ ✝ ✎ ✤ ✍ ✠ ☞ ✥ ✦ ✆ ✝ ✁ ✞ ☛ ✠ ☞ ✜ ✢ ✍ ✎ ✏ ✍ ✠ ☞ ✞ ✝ ✠ ✑ ✑ ✄ ✝ ✜ ✢ ✒ ✓ ☞ ✁ ✔ ✑ ✄ ✕ ✖ ✧
★ ✩ ✪ ✫ ✬ ✭ ✮ ✯ ✯ ✫ ✰ ✱ ✯ ✲ ✰ ✳ ✴ ✵ ✫ ✶ ✰ ✴ ✫ ✯
the Multi-Angle CIR Receiver to the other front USB port then try again.
Step5.
Enter Windows. Execute ASRock's support CD and install the CIR Driver.
(It is listed at the bottom of driver list.)
26
, please shut down your system and install
ASRock Q77M vPro Motherboard
USB 2.0 header (9-pin, black)
CIR header (4-pin, gray)
USB_PWR
P-
P+
GND
DUMMY
GND
IRTX
IRRX
ATX+5VSB
Publicidad
Tabla de contenido
