Descargar Imprimir esta página

Connection Panel - Montarbo T10P Manual De Instrucciones

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Connection panel

2
1
The system is fitted with both Jack and Speakon
maximum flexibility. The four sockets are connected in parallel.
1
Input jack sockets: they are best suited for mobile (touring)
applications or when it is expected to frequently disconnect the
system. Use one of them (at your choice) for connection to the
power amplifier or the powered mixer output. Use the other one‚
if needed, for parallel connection of another speaker system.
Always pay attention to the total impedance.
Unscreened Jack connector
1
GND
1
GND = Ground
2
+
= Hot
Wiring of the connection cable to the Speakon
1 - Strip the cable for 20 mm of length and strip each wire for
8 mm of length . We suggest to use a cable with 1,5 ÷ 2mm
section wires (the insert terminals are however suitable for a cable
with wires up to a section of 4mm
2 - Insert the cable into the bushing and into the chuck (white chuck
for a cable diameter of 5 ÷ 11mm; black chuck for a cable diameter
of 9.50 ÷ 15mm).
Fit a ferrule at the end of each wire and connect wires on the insert.
3 - The wire ends can be clamped in the terminals using a PZ1
screwdriver or soldered. Always pay attention to the symbols
shown on the connector body ! : connect the positive wire to the
terminal labelled 1+, the negative wire to the terminal labelled 1- .
Terminals 2+ and 2- are not used.
4 - After connecting the wires to the insert, lead it through the
body and screw down the body with the bushing.
Mating connector is a Neutrik Speakon
If not available, model NL2-FC may be used: this version has
contacts 1+ and 1- only.
The trademark Neutrik Speakon
is property of Neutrik
®
connectors to achieve
®
2
2
+
+
1
GND
connector:
®
2
/12AWG).
model NL4-FC.
®
Passive loudspeaker systems
Connections are the same for the four models.
Never connect two power amplifiers to the same
speaker system: doing this may result in serious damage
to the amplifiers.
®
2
Speakon
connectors: this is the better choice for critical
installations, because the locking connector avoids accidental
disconnection.
8 mm
1
2
WIRES
2
FERRULES FOR
STRANDS
3
INSERT
4
HOUSING
T18P / T15P / T12P / T10P
20 mm
WIRES
CABLE
CHUCK
INSIDE VIEW
®
SPEAKON
CONNECTOR
CABLE
BUSHING
SETSCREWS
9
ENGLISH

Publicidad

loading

Este manual también es adecuado para:

T12pT15pT18p