3M Peltor HY100 Manual Del Usuario página 63

An
INTENDED USE
These products are designed to help reduce
exposure to hazardous noise levels and loud
sounds. These products are available in neckband
version and are intended to be used in Behind-The-
Neck wearing mode only.
These products are primarily intended for use with
3M welding shields, for example the 3M™
Speedglas™ 9100.
^ Particular attention should be given to
warning statements where indicated.
WARNING
^
Always be sure that the complete product is:
- Suitable for the application;
- Fitted correctly;
- Worn during all periods of exposure;
- Replaced when necessary.
This product may be adversely affected by
certain chemical substances. Contact 3M for
additional information.
Leave the area immediately if the hearing
protector becomes damaged.
The tting of hygiene covers to the cushions
may affect the acoustic performance of the
ear muffs.
Never modify or alter this product. Replace
parts only with original 3M spare parts.
Ear muffs, and in particular cushions, may
deteriorate with use and should be examined
at frequent intervals for cracking and leakage,
for example.
The acoustic seal may be adversely affected
by wearing other equipment, such as
spectacles, respirators etc. This may reduce
attenuation. If in doubt, contact an
occupational hygienist, safety professional
or3M representative on the Tech Assist
Helpline 3M Australia 1800 024 464, 3M New
Zealand 0800 364 357..
When worn, hearing protectors reduce
ambient sounds which may affect warning
signals and vital communication. Always
ensure that you select the right product to
match the working environment so that vital
communication and emergency sounds
remain audible.
Proper selection, training, use and appropriate
maintenance are essential in order for the
product to help protect the wearer from noise
hazards.
Particular attention should be given to warning
statements where indicated.
Failure to follow all instructions on the use of
these personal protection products and/or
failure to properly wear the complete product
during all periods of exposure may adversely
affect the wearer's health, lead to severe or
life threatening illness or permanent disability.
See all instructions for use and save for
continuing reference.
FITTING INSTRUCTIONS
Prior to tting, inspect the product to ensure it is not
damaged. If this is discovered dispose of
immediately and obtain a new pair. Brush excess
hair aside and remove any ear jewellery that may
affect acoustic seal before attempting to t the
hearing protector.
1. Pull the cups apart and place the ear muffs over
the ears so that the cushions form a snug seal
around the ears (Figure 1).
2. Adjust the height for optimum comfort and t by
sliding the cups up or down the yolk whilst holding
the headband in place (Figure 2).
3. Shows the product correctly tted (Figure 3).
FIT CHECK
When hearing protectors are correctly worn your
own voice should sound hollow and sounds around
you should not sound as loud as before.
For optimum noise reduction the cushions should
62