Publicidad
Idiomas disponibles
Idiomas disponibles
2. WHY DOES THE ELECTRIC DRILL STOP
RUNNING BEFORE THE SCREW IS TIGHTENED?
Confirm whether the mode switching ring is on position
, and adjust the torque regulating ring to a higher
position. The tripping torsion corresponding to position
1 is the smallest, and that corresponding to position
20 is the largest. Adjust the mode change-over ring to
position
for maximum torque (no trip), and you can
also adjust the mechanical shift lever to the low speed
(position 1) for greater mechanical transmission torque.
3. WHY IS THE WORKING TIME OF THE SAME
BATTERY PACK SOMETIMES LONG AND
SOMETIMES SHORT?
As mentioned above, if a battery pack is left unused
for too long, its working time will be shortened. Such
situation will be improved after charging and using
for several times. Under doing heavy work, such as
screwing big screw into hard wood, the battery power
will be consumed very fast. Do not charge in the
environment below 0 or above 40℃, which will also
affect the performance of the battery pack.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
10
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
EN
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
FOR BATTERY TOOL
The ambient temperature for use and storage of the
tool and battery ranges from 0 -45℃.
The recommended charging environment temperature
range during charging is 0 - 40℃.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product
Description Battery-powered Drill
Type KUC10 KUC10.2 KUC10.9 (C10-
designation of machinery, representative of
Impact Drill)
Function Drilling
Complies with the following Directives:
2006/42/EC
2011/65/EU&(EU)2015/863
2014/30/EU
Standards conform to
EN 55014-1
EN 55014-2
EN 62841-1
EN 62841-2-1
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
2020/05/25
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China
Publicidad
