Symbols on the Product
On the products you will fi nd symbols that indicate warnings or provide information:
•
Warning: The nozzles become hot during operation.
•
If the hair dryer is used in the bathroom, remove the mains plug after use as water
represents a hazard. This also applies when the hair dryer is switched off.
•
Do not put objects, hair or your hands in front of the air intake opening! The device can
suffer damage despite the overheating protection if the airfl ow is blocked!
•
Please ensure that the inlet grille remains free of fl uff and hairs. Danger of fi re!
•
As additional protection we recommend the installation of a fault current protection
device (RCD) with a rated current of not more than 30 mA in the wiring system of the
bathroom. Please contact an authorised electrician for advice.
1. Fully unwind the mains cable. Fold the handle down.
2. Make sure that the iron voltage (see name plate) and the mains voltage match. The volt-
age can be changed from 110 V to 230 V by means of the voltage switch on the bottom
of the handle.
3. Fit on a nozzle. You can dry single hair locks by concentrating the fl ow of hot air with
the hairdressing nozzle. The diffuser is the ideal solution to dry curly hair without losing
GB
volume. In order to replace the attachment, fi rst remove the old attachment by pulling it
off and then pushing on the new one until it clicks into place.
4. Insert the plug into a duly installed 230 V/50 Hz protective contact socket.
5. Shift the switch on the handle to one of the desired heat/blowing levels:
Switch-off
•
After use shift the switch to position „0" and pull out the plug. Leave the device to cool
before putting it away! To this purpose place the device on one side of the housing or
hang it up by the suspension lug.
•
Fold the handle upwards to save space when storing the device in the see-through bag.
32
05-HTD 3216 Neu.indd 32
05-HTD 898 CB Neu.indd 32
Special safety instructions for this device
Warning of electric shock!
Do not use this device near baths, wash basins or other
vessels containing water.
Commissioning
Level 0:
off
Level 1:
medium airfl ow and medium temperature
Level 2:
strong airfl ow and high temperature
01.12.2008 12:04:57 Uhr
01.12.2008 12:04:57 U