MIRKA BCA 108 Manual De Instrucciones página 96

en | us • ca
Charging procedure
• Connect the power cord to the charger, and then plug into an outlet before inserting battery pack All three charging
lights will be on for two seconds and then turn off
• Insert the battery pack into the charger
• During the charging process, the charging lights will indicate the status as follows:
– Three charging lights will flash in sequence during the charging process
– Fully charged, all three lights will remain on continuously
• The charging process will last approximately 40 minutes for BPA 10820, 50 minutes for BPA 10825 and 100 minutes
for BPA 10850 battery pack
NOTE: This charger can only charge Mirka 10 8 V battery packs
NOTE: Charging times may be longer depending on the surrounding temperature and battery conditions
LED indication of 10.8 V charger
LED
3
2
1
Pre-charge
(Trickle charge)
Steady glow
Charger diagnostics
The charger will indicate if:
• A battery pack is overheated All three charging lights will flash Remove the battery and allow it to cool down for
15–30 minutes and re-insert
• A malfunction occurs in the battery or the charger Two charging lights will flash Remove the battery and allow it to
cool down Re-insert the battery pack into the charger If two charging lights still flash, the battery or charger may
require service
Disposal information
DANGER: Disposal guidelines for old appliances Render redundant power tools unusable by
removing the power cord Only for EU countries Do not dispose of electric tools along with household
waste According to European Directives 2011/65/EU, 2012/19/EU + 2003/108/EC on waste electrical
and electronic equipment and its implementation under national law, electric tools that have reached
the end of their life must be collected separately and taken to an environmentally compatible
recycling facility
96
Mirka® BCA 108 • Battery charger
Charging... Charging...
Flashing
Charging finished Over temperature Battery failure