Transport; Storage - AL-KO solo 442 Instrucciones De Funcionamiento

EN

9 TRANSPORT

Transporting the appliance between two
working areas
■
Switch off the motor.
■
Hold the appliance by the handles.
■
Avoid obstructing anyone with the vacuum or
blow tubes.
■
Never bump anything with the vacuum or
blow tubes.
Transporting the appliance in a vehicle
■
Switch off the motor.
■
Remove the vacuum and blow tubes as well
as the exhaust air manifold and the collecting
sack from the appliance.
■
Put the appliance into the vehicle and fix in
place. This avoids it tipping over when driving
and the petrol/oil mixture running out.
■
Place all accessory parts (where possible
from the size) in the collecting sack and close
it. This avoids uncontrolled movement in the
vehicle when driving.

10 STORAGE

If you are not going to use the appliance for
longer than 2 – 3 months, the following work is
necessary to avoid any damage:
1. Empty the fuel tank:
■
Let the motor turn until it stops by itself.
Then there is no longer any petrol/oil mix-
ture in the fuel tank and in the carburettor
and deposits cannot form.
2. Cleaning the appliance:
■
Wipe the entire appliance and accessory
parts with a cleaning rag. Do not use pet-
rol or other solvents.
■
Shake out the collecting sack. Remove
any adhering, vacuumed material with a
hand brush.
■
Remove any dirt from all appliance open-
ings (including intake grille and cooling
openings for the motor).
■
Open the intake grille and clean the
shredding blade and the rotor. Lightly oil
the shredding blade using a cleaning rag.
3. Oiling the cylinder:
■
Let the appliance cool down completely.
■
Pull off the spark plug connector and un-
screw the spark plug.
46
■
Drop a little oil into the spark plug open-
ing.
■
Slowly pull on the starter handle so the
piston moves and the oil is distributed in
the cylinder.
■
Screw the spark plug back in tightly and
plug in the spark plug connector.
4. Store the appliance in a dry place where pos-
sible.
Transport
Saug-/Blasgerät 442