TechniSat HDTV 46 Guia De Inicio Rapido página 14

Switching the equipment on/off
6 Operation
6.1 Turning the TV set on and off
6.1.1 Turning on with the mains switch on the TV set
> Switch the TV set on by pressing the mains switch.
The TV set now runs through an initialisation procedure and cannot be operated
during this period. This procedure can take the few seconds.
6.1.2 Turning on from the standby mode
> Switched the TV set on by pressing the On/Standby key or the Programme +/- keys
on the remote control /on the TV
on the remote control. The green LED display signals the operating condition.
6.1.3 Switching to the standby mode
> Turn the TV set off by pressing the On/Standby key on the remote control/on the set
Please note that when the set is switched off it also checks whether a new operating software
or programme list is available. This procedure can take some time. The LED shines orange
3)
and the LCD panel is already switched off during the test.
The television set is turned on again immediately, if the On/Standby key is pressed during the test.
The television set switches to standby after the test has been carried out, the LED now shines red.
The TV set is now in the standby mode and can be completely switched off with the mains switch.
If new operating software
this is displayed when the TV set is switched on the next time.
The new software or programme list can then be downloaded immediately.
6.1.4 Turning off with the mains switch on the TV set
> The TV set is completely turned off by pressing the mains switch.
Please note that in this case neither software nor "SFI+" data
can be downloaded and the timer can also not be used.
Please note that the TV set may only be turned off with the mains switch when it is in the
standby mode. This prevents the loss of data and possible damage to the files or hard disk.
The device remembers, whether it was set to "On" or "Off",
as entered with the remote control or keys of the set
In the case of an electrical power outage, the TV set should therefore be switched off
during ongoing operation with the mains switch to prevent it turning itself on
inadvertently as soon as power is available again.
1) Only possible with the remote control for HDTV 32 Plus and HDTV 40 Plus.
2) Only from DVB-S (ASTRA 19.2° East) and DVB-C/DVB-T (when data channel is available).
3) Only from DVB-S (ASTRA 19.2° East).
or by pressing one of the numeric keys from 0 to 9
1)
or a new programme list
2)
was found during the test,
3)
.
1)
14
.
1)
2)