Publicidad
Idiomas disponibles
Idiomas disponibles
13. Remove the HDC cable from the box
14. Fit the 5-pin socket to the base of the arm from underneath the turntable taking
care to align it correctly to avoid damaging the pins in the arm base
15. At the same end of the cable there is an earth lead, this is connected to the earth
terminal located next to the arm base again this is done from the underside of the
turntable
16. Dress/secure the cable in place as appropriate
17. The arm is now installed on the turntable and ready to receive a cartridge
4
roksan.com
T O F I T A C A R T R I D G E T O T H E S A R A :
Establish the correct tracking weight (down-force) from the cartridge's
instructions
Decide whether you wish to fit the optional finger lift (supplied with the
Sara) when fitting the cartridge and select the correct length of bolt
(supplied with cartridge)
If the cartridge has a removable stylus, it is recommended that as much of
the fitting process is done with it removed
1.
With a pair of small pliers, connect the wires under the head shell to the cartridge
pins taking care to match the colours together
2.
Fix the cartridge to the head shell starting with the bolt on the left. If you're
choosing to use the finger lift, fit at this stage on the top side of the head shell –
finger tighten
3.
Repeat step 2 for the bolt on the right
4.
To start with, line the front of the cartridge up so its front edge is parallel with the
front edge of the head shell
5.
Refit the stylus if it was previously removed
6.
Get some scales ready to measure the tracking weight (down-force)
7.
Slide the counterweight back about half way by loosening
the grub screw and release the arm retaining clip ensuring
that the arm lift lever is in the up position (pushed back)
8.
If the turntable has a mat, remove it and place the scales on
to the platter and set them at 'zero'
Sara
5
Publicidad
