Vicks NaturalCare VUL530 Serie Manual Del Usuario página 5

Setting Up Your Humidifier
1.
Remove packging materials. Keep instructions.
2.
Remove twist tie and extend power cord.
3.
Place on a firm, level, water resistant surface a minimum of
12" (30cm) from any walls.
Filling/Refilling
NOTE: Tank should be carried using two hands. One hand using carrying handle located on tank top
and other hand supporting the base of the tank.
This Humidifier holds .6 gallon (1.9L) of water (tank and reservoir combined).
Always turn the humidifier off before removing the Water Tank.
Step 1 Step 2
1.
Remove Tank and turn upside down.
2.
Remove Tank Cap in the direction of the open lock symbol.
3.
Fill Tank with cool water. Do not fill with warm or hot water.
4.
Securely replace Tank Cap, aligning arrow to lock symbol.
5.
Place Tank back on Base.
CAUTION: USE CARE WHEN HANDLING WATER TANK TO AVOID UNNECESSARY IMPACT.
BANGING OR DROPPING THE WATER TANK COULD RESULT IN DAMAGE TO THE TANK THAT
WILL CAUSE LEAKING.
Operating
Step 1
1.
Power: With the Power Knob in the off position, plug humidifier into a polarized 120V outlet.
Caution: To avoid electric shock do not plug humidifier into outlet with wet hands.
2.
Humidity Output: Turn the Power Knob to highest setting.
3.
Humidity Level: When a comfortable humidity level is reached turn Power Knob to a lower
setting. A comfortable humidity level is between 40-60%.
To monitor your humidity level use a humidity monitor such as the Vicks V70 or
V70-CAN model.
Step 3
Step 2
Step 4
Step 3
Step 3
Step 5
Step 4
5