Publicidad
Idiomas disponibles
Idiomas disponibles
−
If the tool continues to be overloaded and the
indication
lamp
approximately two seconds, the tool stops. This
prevents the motor and its related parts from being
damaged.
In this situation, turn the tool off and stop the
application that caused the tool to become
overloaded. Then turn the tool on to restart.
Battery cartridge replacing signal
When the remaining battery capacity gets small, the
indication lamp lights up during operation earlier than
enough capacity battery use.
Accidental re-start preventive function
Even if the battery cartridge is installed on the tool with
the slide switch in the "I (ON)" position, the tool does not
start.
To start the tool, first slide the slide switch toward the "O
(OFF)" position and then slide it toward the "I (ON)"
position.
Adjusting the depth of groove
3
2
014907
6 grooving depths can be preset according to the size of
biscuit to be used.
Refer to the table below for the correspondence
between the sizes marked on the stopper and the
biscuit size. Fine adjustments to the grooving depth can
be made by turning the adjusting screw after loosening
the hex nut. This may become necessary after the blade
has been resharpened a few times.
Size on stopper
0
Biscuit size
0
8 mm
10 mm
Depth of groove
(0.3")
(0.4")
* With the rubber spikes removed.
012683
Angle guide
The angle guide height can be moved up and down to
adjust the position of the blade in relation to the top of
the workpiece.
continues
to
light
1. Pointer
1
2. Stopper
3. Adjusting screw
4. Rubber spike
4
10
20
S
D
10
20
-
-
12.3mm
13 mm
14.7mm
(0.48")
(0.51")
(0.58")
up
for
6
7
2
3
014896
To adjust the angle guide height, loosen the lock lever
down and rotate the knob until the pointer points to the
desired scale graduation marked on the angle guide.
1
012498
Then tighten the lock lever up to secure the angle guide.
The scale on the angle guide indicates the distance
from the top of the workpiece to the center of the blade
thickness.
The angle guide is removable from the fence according
to the need of your work. To remove the angle guide,
loosen the lock lever and turn the knob clockwise until it
comes out of the upper end of the fence.
Fence
1
MAX
-
*
20 mm
014897
(0.8")
The angle of the fence can be adjusted between 0° and
90° (positive stops at 0°, 45° and 90°). To adjust the
angle, loosen the lock lever and tilt the fence until the
pointer points to the desired graduation on the angle
scale. Then tighten the lock lever to secure the fence.
6
1
5
4
2
3
4
5
4
3
2
1. Lock lever
2. Angle guide
3. Knob
4. Scale
5. Pointer
6. Tighten
7. Loosen
1. Knob
2. Down
3. Up
4. Center of blade
thickness
1. Fence
2. Angle scale
3. Lock lever
4. Tighten
5. Loosen
Publicidad
