dirna Bergstrom bycool FLAT ACTROS 2011 Instrucciones De Montaje página 34

FLAT
ES
EN
1- Lead equipment power cable up to the vehicle´s battery, gluing plastic supports on rear cabin
side and fastening it with flanges. Once cabin has been folded, lead cable along lower cabin
side, fastening it with clamps and M4 screws and up to battery with flanges. It must follow the
same passage as original cable (thoroughly clean the area before gluing plastic supports). When
connecting equipment to battery, it will carry out a test of all its leds, CP will show on the display
and it will then be turned off.
IMPORTANT: Due to the complex electronic control system of the unit, the current
supply connection must be made directly to the battery, not to any other existing point
available to feed other vehicle accessory or appliance, taking care of not changing
polarity (2). Should polarity be inverted, electronic system of the unit could irreversebly
be damaged.
IMPORTANT: Please consult User's Guide before starting.
DETAILED INSTRUCTIONS
ON POWER WIRING ASSEMBLY
1
2
+
Cableado de
alimentación
34
®
2
-